Parkside HG10714 Instructions D'utilisation Et Consignes De Sécurité page 16

Press the inch / mm key
measurement (inch or mm) you wish to use.
Either "mm" or "in" will appear to the right of the
figures in the LCD display
Press the key to obtain the zero setting (ZERO)
in order to reset the LCD display
9 ] [
Tip: The LCD display
switch on by moving the internal measuring jaws
or the external measuring jaws
Measuring an object from the outside
(see Fig. C.1):
Move the external measuring jaws
by turning the handwheel
clockwise. Place the external measuring jaws
against the object to be measured.
Turn the handwheel
the external measuring jaws
they touch both sides of the object you want to
measure. Please ensure that you do not damage
the object you want to measure by subjecting it to
too much pressure.
The LCD display
Measuring an object from the inside
(see Fig. C.2):
Place the internal measuring jaws
object you want to measure.
Turn the handwheel
Move the internal measuring jaws
they touch the object on both its inner sides.
Please ensure that you do not damage the object
you want to measure by subjecting it to too much
pressure.
The LCD display
Measuring the depth of an object
(see Fig. E.1):
Move the depth-measuring blade
caliper.
Put the depth-measuring blade
it touches the surface (e.g. inside a hole).
Slide the body of the caliper
to set the unit of
[ 3 ]
[ 5 ]
will also automatically
5 ] [
[ 11 ]
[ 7 ]
inwards clockwise. Move
7 ] [
11 ] [
now displays the dimensions.
[ 5 ]
outwards anti-clockwise.
[ 7 ]
now displays the dimensions.
[ 5 ]
.
to zero.
[ 5 ]
.
apart
11 ] [
outwards anti-
together until
against the
2 ] [
apart until
2 ] [
out of the
[ 6 ]
in position until
[ 6 ]
downward until
12 ] [
GB/IE/NI
2 ] [
11 ] [
13