BRAND Titrette Mode D'emploi page 59

Dismantling instrument · Component replacement
e) Lift the safety ring of the piston/cylinder assembly and
check that the nut and bolt mesh securely. Then,
screw in the safety ring hand tight (Fig. e).
f) Set the mounting tool on the right-hand edge of the
housing, and tighten it towards the left-hand edge
(Fig. f).
Replace the mounting tool into the rear housing for
storage.
g) Slide in the piston rod locking mechanism to the stop.
h) Connect the rear housing firstly at the top, then snap it
closed and screw in the air vent cap.
i) Carry out a function check and calibration, and make
any necessary adjustments.
Cleaning
e
f
59