BRAND Titrette Mode D'emploi page 58

Cleaning
3.
Mounting the titrating tube and the top part of the housing
a) Mounting the titrating tube (Fig. a):
1.) Slide out the titrating tube approx. 5 mm further.
2.) Press the housing of the titrating tube all the way to
3.) Then, slide the titrating tube up to the stop.
4.) Slide the titrating tube housing down to lock.
b) Pull up the valve lever to the 'Recirculate' position,
and press it in tightly (Fig. b).
c) Check that the piston rod bar has been pulled out
(Fig. c).
d) Attach the top part of the instrument, and rotate the
hand wheels to move it down while being careful that
the recess of the front casing slides snugly over the
titrating tube.
Rotate the top part slightly if necessary (Fig. d).
(Continued on next page!)
58
the top.
Dismantling instrument · Component replacement
a
b
c
d