Publicité
Les langues disponibles
Les langues disponibles
64A
ONLY PL
VERSION
The remote control device for regulating the welding
current is connected to the front panel by means of
a multipole connector.
To regulate the current from the PHG1B, move the
switch (7), located above the multipole connector
(8), to "ON" position.
The remote control of the polarity inverter (64A), if
installed, permits to inverse the polarity directly
from the control itself.
MAKE SURE
When the PHG1B is not used, make sure that the
switch is in the "LOCAL" position.
Position the (T) welding current adjusting knob at
the necessary current value in order to obtain the
necessary amps, according to the diameter and
type of electrode.
REMOTE CONTROL PHG1B-PHG1B/PL
POLARITY SWITCH
1
2
9
8
4
5
7
6
3
PUSH AND
SCREW TIGHT
KHM 351
7
8
M
38.7
Publicité
