Publicité
Les langues disponibles
Les langues disponibles
6
Operating the product
Read the "Safety Instructions" section
first!
The operating temperature is regulated by
the temperature control.
Warm
MIN
MIN = Lowest cooling setting (Warmest
setting).
MAX = Highest cooling setting (Coldest
setting).
The average temperature inside the fridge
should be around +5°C.
Please choose the setting according to the
desired temperature.
Please note that there will be different
temperatures in the cooling area.
The coldest region is immediately above
the vegetable compartment.
The interior temperature also depends on
ambient temperature, the frequency with
which the door is opened and the amount
of foods kept inside.
Frequently opening the door causes the
interior temperature to rise.
For this reason, it is recommended to
close the door again as soon as possible
after use.
Figures that take place in this instruction manual are schematic and may not
correspond exactly with your product. If the subject parts are not included in the
product you have purchased, then it is valid for other models.
Refrigerator / User manual
Cold
MAX
* May not be available in all models
13 / 21 EN
Thermostat setting button
The interior temperature of your refrigerator
changes for the following reasons:
•
Seasonal temperatures.
•
Frequent opening of the door and
leaving the door open for long periods.
•
Food put into the refrigerator without
cooling down to the room temperature.
•
The location of the refrigerator in the
room (e.g. exposing to sunlight).
•
You may adjust the varying interior
temperature due to such reasons by
using the thermostat. Numbers around
the thermostat button indicates the
cooling degrees.
•
If the ambient temperature is higher
than 32°C, turn the thermostat button to
maximum position.
•
If the ambient temperature is lower than
25°C, turn the thermostat button to
minimum position.
Defrost
Fridge compartment
Fridge compartment performs fullautomatic
defrosting.
Water drops and a frosting up to 7-8 mm
can occur on the inner rear wall of the
fridge compartment while your refrigerator
cools down. Such formation is normal
as a result of the cooling system.
The frost formation is defrosted by
performing automatic defrosting with
certain intervals thanks to the automatic
defrosting system of the rear wall. User
is not required to scrape the frost or
remove the water drops.
Water resulting from the defrosting passes
from the water collection groove and flows
Publicité
