Publicité
Les langues disponibles
Les langues disponibles
4
Installation
Read the "Safety Instructions" section
first!
4.1. Appropriate Installation
Location
Contact an Authorized Service for the
installation of the product. In order to
prepare the product for use, refer the
information in the user manual and ensure
that electrical installation and water
installation are appropriate. If not, call a
qualified electrician and technician to have
any necessary arrangements carried out.
WARNING:
Manufacturer shall not be held
liable for damages that may arise
from procedures carried out by
unauthorized persons.
WARNING:
Product must not be plugged in
during installation. Otherwise,
there is the risk of death or
serious injury!
WARNING:
If the door clearance of the room
where the product shall be place
is so tight to prevent passing of
the product, remove the door of
the room and pass the product
through the door by turning it to its
side; if this does not work, contact
the authorized service.
•
Place the product on an even floor
surface to prevent jolts.
•
Install the product at least 30 cm away
from heat sources such as hobs, heater
cores and stoves and at least 5 cm
away from electrical ovens.
•
Product must not be subjected to direct
sun light and kept in humid places.
Appropriate air ventilation must be
•
provided around your product in order
to achieve an efficient operation. If the
product is to be placed in a recess in
the wall, pay attention to leave at least 5
cm distance with the ceiling and side
walls.
•
Please provide at least 5cm distance for
air circulation between the back side of
your product and the wall to avoid
condensation on the rear panel of
product.
•
Your product requires adequate air
circulation to function efficiently. If the
product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and the
ceiling, rear wall and the side walls.
•
If the product will be placed in an
alcove, remember to leave at least 5 cm
clearance between the product and the
ceiling, rear wall and the side walls.
Check if the rear wall clearance
protection component is present at its
location (if provided with the product). If
the component is not available, or if it is
lost or fallen, position the product so
that at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance
at the rear is important for efficient
operation of the product.
4.2. Adjusting the Feet
If the product stands unbalanced after
installation, adjust the feet on the front by
rotating them to the right or left.
4.3. Electrical Connection
WARNING:
Do not make connections via
extension cables or multi-plugs.
WARNING:
Damaged power cable must be
replaced by the Authorized
Service Agent.
10 / 21 EN
Refrigerator / User manual
Publicité
