Publicité
Les langues disponibles
Les langues disponibles
Safety Instructions
1.3. Electrical safety
•
The product shall not be plugged into
the outlet during installation,
maintenance, cleaning, repair, and
transportation operations.
•
If the power the cord is damaged, it
shall be replaced by authorized service
only to avoid any risk that may occu.
•
Do not tuck the power cord under the
product or to the rear of the product. Do
not put heavy items on the power cord.
The power cord should not be bent,
crushed, and come into contact with
any heat source.
•
Do not use an extension cord, multi-plug
or adaptor to operate your product.
•
Portable multi sockets or portable power
supplies may overheat and cause fire.
Thus, do not have a multi-plug behind
or in the vicinity of the product.
•
The plug shall be easily accessible. If
this is not possible, a mechanism that
meets the electrical legislation and that
disconnects all terminals from the mains
(fuse, switch, main switch, etc.) shall be
available on the electrical installation.
•
Do not touch the plug with wet hands.
•
When unplugging the appliance, don't
hold the power cord, but the plug.
1.4. Handling Safety
•
This product is heavy, do not handle it
by yourself.
•
Do not hold the product from its door
while handling the product.
•
Be careful not to damage the cooling
system and the pipes while handling the
product. Do not operate the product if
the pipes are damaged, and contact an
authorized service.
1.5. Installation Safety
•
Contact the Authorized Service for the
product's installation. To prepare the
product for installation, see the
information in the user guide and make
sure the electric and water utilities are
as required. If the installation is not
suitable, call a qualified electrician and
plumber to have them make the
necessary arrangements. Otherwise,
electric shock, fire, issues with the
product or injuries may occur.
•
Check for any damage on the product
before installing it. Do not have the
product installed if it is damaged.
•
Place the product on a level and hard
surface and balance with the adjustable
legs. Otherwise, the refrigerator may tip
over and cause injuries.
•
The product shall be installed in a dry
and ventilated environment. Do not
keep carpets, rugs or similar floor
covers under the product. This may
cause risk of fire as a result of
inadequate ventilation.
•
Do not block or cover ventilation holes.
Otherwise, power consumption may be
increased and damage to your product
may occur.
•
Do not connect the product to supply
systems such as solar power supplies.
Otherwise, damage to your product may
occur as a result of the abrupt voltage
fluctuations.
•
The more refrigerant a refrigerator
contains, the bigger its installation room
shall be. In very small rooms, a
flammable gas-air mixture may occur in
case of a gas leak in the cooling system.
At least 1 m
each 8 grams of refrigerant. The amount
of the refrigerant available in your
product is specified in the Type Label.
•
The installation place of the product
shall not be exposed to direct sunlight
and it shall not be in the vicinity of a heat
source such as stoves, radiators, etc.
If you cannot prevent installation of the
product in the vicinity of a heat source, you
shall use a suitable insulation plate and the
minimum distance to the heat source shall
be as specified below.
-
At least 30 cm away from heat sources
such as stoves, heating units and
heaters, etc.
04 / 21 EN
of volume is required for
3
Refrigerator / User manual
Publicité
