Flex LBP 125-15 18-EC Notice D'instruction D'origine page 16

■ Recharge batteries only with chargers
recommended by the manufacturer. A
charger that is suitable for one type of
battery may create a fire hazard when used
with another battery.
■ The battery may be damaged by pointed
objects such as e.g. nails or screwdrivers or
by external application of force. This may
give rise to an internal short circuit, causing
the battery to burn, smoke, explode or
overheat.
Special safety instructions
■ The mains voltage and the voltage
specifications on the rating plate must
correspond.
■ Do not press the spindle lock until the
grinding tool stops.
Noise and vibration
The noise and vibration values have been
determined in accordance with EN 60745.
The A evaluated noise level of the power tool
is typically:
– Sound pressure level L
– Sound power level L
– Uncertainty:
Total vibration value:
– Emission value a
– Uncertainty:
CAUTION!
The indicated measurements refer to new
power tools. Daily use causes the noise and
vibration values to change.
NOTE
The vibration emission level given in this
information sheet has been measured in
accordance with a standardised test given
in EN 60745 and may be used to compare
one tool with another. It may be used for a
preliminary assessment of exposure. The
declared vibration emission level represents
the main applications of the tool. However if
the tool is used for different applications, with
different accessories or poorly maintained,
the vibration emission may differ. This may
significantly increase the exposure level over
the total working period.
However if the tool is used for different
applications, with different accessories or
16
: 74 dB(A);
pA
: 92 dB(A);
WA
K = 3 dB.
: 6.75 m/s
h
K = 1.5 m/s
poorly maintained, the vibration emission
may differ. This may significantly decrease the
exposure level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
CAUTION!
Wear ear protection at a sound pressure
above 85 dB(A).
Technical data
Tool
Type
Nominal
voltage
Max. grinding
tool Ø
Spindle thread
Speed
Weight
according
to "EPTA
Procedure
01/2003"
2
(without
2
battery)
Battery
Weight of
battery
Working
temperature
Storage
temperature
Charging
temperature
Charger
LBP 125-15 18-EC
LBP 125-15 18-EC
Angle grinder
V 18
mm 125
M14
r.p.m. 10,000
kg 1.87
AP 18/2.5
18V AP 18/5.0
AP 18/8.0
AP 18/2.5
kg AP 18/5.0
AP 18/8.0
-10-40°C
< 50°C
4-40°C
CA 12/18, CA 18-LD
0.4
0.7
1.1