Parkside PBSA 12 D2 Traduction Des Instructions D'origine page 26

GB IE
ance could also become live
and cause an electric shock.
8) SAFETY INFORMATION
FOR USING LONG DRILLS
a) Do not work at a speed
higher than the maximum
permissible speed for the
drill. Higher speeds can cause
the drill to bend slightly when
rotating freely without contact
with the workpiece and can
also cause injury.
b) Always begin drilling at
a low speed and when
the drill is in contact with
the workpiece. Higher
speeds can cause the drill to
bend slightly when rotating
freely without contact with the
workpiece and can also cause
injury.
c) Do not apply excessive
pressure to the drill. Only
apply pressure lengthwise
along the drill. Drills can
bend and break or cause a loss
in control, thus resulting in inju-
ries.
The device is part of the
Parkside X 12 V TEAM
series and can be oper-
ated using X 12 V TEAM
series batteries. The
26
batteries may only be
charged using charg-
ers from the Parkside
X 12 V TEAM series.
Attention! Observe the
safety information and
notes on charging and
proper use as shown in
the instruction manual
for your battery and
charger from the Park-
side X 12 V Team se-
ries.
9) RESIDUAL RISKS
Even if properly operating and
handling this electric tool, some
residual risks will remain. Due to its
construction and build, this electric
tool may present the following haz-
ards:
a) Cuts
b) Ear damage if working without
ear protection.
c) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
Warning! During operation,
this electric tool generates an
electromagnetic field which,