Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Wire Rope Winch >LAMBDA< 300 kg
English
for stages and studios BGV C1
Before taking into operation, please carefully read this operating instructions!
Observe the safety instructions!
File documentation!
Destined use
The wire rope winch >LAMBDA< with spur gear is a manually operated winch for suspension devices in stages
and studios acc. to UVV BGV C1 (VBG 70) for lifting and lowering of loads.
Not suitable for use in explosive danger area.
Power operation is not allowed.
The winch is not designed for continuous operation.
Alterations to the winch or fitting of accessories are only allowed with our written approval.
Pay attention to the technical data and functional description!
Regulations for the Prevention of Accidents
Observe any rules which are valid for the respective country.
Presently valid in Germany:
UVV BGV D8 winches- lifting and pulling devices
UVV BGV C1 stages and studios(4.98)
DIN 56925 Stage technique - Scenery hoists
DIN 15020 T 1 and T 2 Rope drives
EC directive 98/37/EC
FEM 9.661 ISO 4308/1
1)
in the respective version
Safety Instructions
Operation, installation and maintenance work should only be executed by personnel who are:
Competent, qualified persons
(definition of experts acc. to IEC 364)
Qualified persons for reasons of their training, experience and instruction are persons who do their necessary
activities without danger and who can avoid this danger due to their knowledge of directives, regulations for the
prevention of accidents and standards. These persons are responsible for the security of the installation.
The supervision of knowledgeable personnel, because ever changing local, technical, safety
conditions may not be adequately registered.
Man riding using the winch to raise, lower or haul people is strictly forbidden. Unnecessary
loads being moved over people is forbidden (acc. to UVV BGV C1).
Never touch moving parts.
Defects must be repaired immediately by competent trained personnel.
The load
ð
must not be left suspended without supervision,
ð
must not be allowed to swing
ð
must not fall into the wire rope
The rope
ð
should only be rolled in one layer on a grooved drum
ð
should only be used for lifting, lowering or pulling of various loads and must not be used for
any other purpose.
ð
at least 3 full turns of rope should remain on the drum when loaded.
ð fleet angle (see picture)
for standard wire rope ≤3°,
for special rope ≤1,5°
ð
when filled to its capacity the drum flanges must project not less than 1.5 times
the diameter of the rope.
ð
examine and service regularly acc. to DIN 15020 page 2
ð
only handle with safety gloves
ð
do not touch the rope inlet
design changes under reserve
04.04.014
1)
page 7
3°
3°
*
*
1,5°
1,5°
*
*
3. 2. 1.
Publicité
Table des Matières
