Mounting Positions - Pfaff LAMBDA Mode D'emploi

Wire Rope Winch >LAMBDA< 300 kg
English
for stages and studios BGV C 1
Mechanical Fixing:
Type
screws (material grade)
Number of screws

Mounting positions

Various rope paths can be applied subject to
the mounting positions as shown.
Pay attention to rope in-take and out-take.
Wire rope fixing
ATTENTION:
With wrong rope coiling the brake is not effective.
Rope coiling has to be effected acc. to the drawing.
ð
Insert the rope in consideration
rope direction
of winding direction.
ð
Tighten the clamping screws
Operating Instructions
Safety Instruction
The winch is only suited for manual operation.
♦ Lifting the load by turning the crank clockwise.
♦ Lowering the load by turning the crank counter-clockwise.
Vario-Crank
The winch is equipped with a vario-crank and a detachable crank arm. The crank arm is adjustable.
Suitable when using the winch in confined areas.
The crank arm with handle ‚ may be detached from the winch.
Detaching the crank arm: (pay attention to freedom of motion)
⇒ loosen the adjusting screw •
⇒ Pull the crank arm via the safety ball ƒ out of the guiding (expenditure of force is required)
⇒ store the crank arm
⇒ slightly tighten the adjusting screw
Fixing the crank arm: (pay attention to freedom of motion)
⇒ loosen the adjusting screw •
⇒ put the crank arm into the guiding, strongly push over safety ball ƒ
⇒ push the crank arm into the required position
⇒ re-tighten adjusting screw •
When pulling or pushing the crank arm make sure that there is
enough free space.
Pulling or pushing with force may cause accidents.
Adjustment
⇒ loosen the adjusting screw •
⇒ bring the crank arm into the required position
⇒ re-tighten adjusting screw •
⇒ Before every use check firm seat of the crank arm
design changes under reserve
04.04.014
030272015; 030272017; 030272018; 030272019
M 12 (min. 8.8)
4
For rope selection pay attention to the technical
data for the rope.
The wire rope must have a 10-fold safety against
breaking related to the lifting capacity.
The diameter of rope rollers have to be at least 20-
fold, the rope drum diameter at least 18-fold, the
rope diameter.
Calculate the rope length in such a way that at least
3 full turns of rope remain on the drum in lowest
load position.
lowering lifting
1
3
2
page 9