Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Compact wire rope winch SW KAL
English
Before taking into operation, please carefully read this operating instruction!
Observe the safety instructions!
File documentation!
Destined use
The worm gear winch is a manually operated winch fixed to a console for lifting and lowering of loads.
Not suitable for use in explosive danger area.
Power operation is not allowed.
The winch is not designed for continuous operation.
Alterations to the winch or fitting of accessories are only allowed with our written approval.
Pay attention to the technical data and functional description!
Regulations for the Prevention of Accidents
Observe any rules which are valid for the respective country.
Presently valid in Germany:
EC directive 2006/42/EC
BGV D8 Winches- lifting and pulling devices
DIN EN 13157 (09.04) Hand powered lifting equipment
BGR 500 – 2.8 Load suspension devices in hoist operation
DIN 15020-1; DIN EN ISO 4308-1 Cranes and lifting appliances-Selection of wire ropes-Part 1: General
DIN 15020-2; DIN EN ISO 4309 Cranes. Wire ropes. Care and maintenance, inspection and discard
FEM 9.661 ISO 4308/1
1)
in the respective version
Safety Instructions
Operation, installation and maintenance work should only be executed by personnel who are:
competent
trained
familiar with the relevant regulations
By non-guided load, use a special non-twisting rope!
Moving of people by the winch or of loads over people is strictly forbidden.
Never touch moving parts.
Competent trained personnel must repair defects immediately.
The load
must not be left suspended without supervision,
must not be allowed to swing
must not fall into the wire rope
The rope
should only be used for lifting, lowering or pulling of various loads and must not be used for any other purpose.
lowerst position at least 3 full turns of rope should remain on the drum when loaded.
max. fleet angle (see picture) for standard wire rope 3°, for special rope 1,5°
when filled to its capacity the drum flanges must project not less than 1.5 times the diameter of
the rope.
examine and service regularly according to DIN 15020 page 2
only handle with safety gloves
do not touch the rope inlet
The Winch
Do not exceed the capacity of each rope layer.
Before taking into operation, a competent person must check:
the lifting device
the load bearing parts of the structure
the carrying medium
mounting
Bildliche Darstellung unverbindlich!
Graphic representation not binding!
04.02.051
1)
Représentation graphique sans engagement!
3°
3°
1,5°
1,5°
3. 2. 1.
7
Publicité
Table des Matières
