hajdu HB300C Manuel De Mise En Service, D'opération Et D'entretien page 57

____________________________________________EN________________________________________12
Before starting any installation operation, please ensure that the planned operation location of
the water heater fulfils the following requirements:
It should be installed in a location larger than a floorspace of 8 m². Do not place the appliance
a)
in a location that may provide favourable conditions for the creation of ice. Do not place the
appliance into a location where another appliance works that requires air for its operation (i.e.
gas furnace, water heater operated by gas, etc.) It is not allowed to use the hot water tank
outdoors or at a place exposed to rain.
In order to ensure adequate operation of the appliance and to ease maintenance, the selected
b)
location has to possess suitable safety distances as measured from the walls and the ceiling
(Figures 7.1.-1 and 7.1-2.)
Feet fixing: Make sure that the flooring is flat enough, possessing adequate stability. With the
c)
help of the „drill frame" (usage manual), set the positions of the feet fixing, taking into
consideration deployment sizes indicated on figures 7.1.-1, and 7.1.-2. of the usage manual.
Mount the 3 feet fixing items attached to the appliance with screws of M8 size and metal hit
anchor drilled into the flooring as minimum (M8x75), while the feet fixing is positioned according
to figure 7.1.-3. Fix the setable feet of the appliance at a distance of min. 26 mm (see figure
7.1.-4.) Push the appliance carefully into the direction of the feet fixing srewed down in a way
that the setable feet are hit up in the open mortice of the feet fixing (figure 7.1.-5.).
If the appliance is operated without any feet fixing, it might turn upside down. In this case,
the manufacturer shall not be liable to any damages emerged.
Before installation, installation space requirements
3.4.
Air outlet
Display
Figure 7.1.-1.
Protective grid
Air inlet