hajdu HB300C Manuel De Mise En Service, D'opération Et D'entretien page 53

____________________________________________EN________________________________________8
product. The constructor, user and installation technician are exclusively responsible for knowledge
and compliance of regulations on the construction, installation, operation and maintenance of the
appliance in their competency areas. References on laws, requirements of technical descriptions used
in this manual are for information only. Newly implemented laws or modifications of efficient laws shall
not be legally binding for the manufacturer against third persons in any way.
2.4. Explanation of applied symbols
Concerning putting into operation of appliance and operation safety of the appliance, the
following symbols are used in order to underline the importance of warnings of danger:
Failure to observe a warning may result in serious injury or in death, in some cases.
Failure to observe a warning may result in serious injury or damage in the building,
in the plants or in the animals.
Compulsory compliance with general and specific safety instructions of the product.
Parts or points written after the expression "WARNING!" and/or written in bold type contain important
information or recommendation and it is indispensable to take them into consideration and to comply
with them.
Package content
2.5.
The appliance is transported in carton box with internal protective elements.
The package contains the following:
Installation, usage and maintenance manual
Flexible conduit to discharge condensate water
Feet fixing
Drill frame
Wire installation rubber
2.6. Transport and handling
During product delivery, please check that there is no visible damage
on the external part of packaging. If the product seems to be damaged, please
turn to the delivery company with your complaint in no delay.
Similar to all equipment containing a compressor, the heat pump must
be stored and transported only in a standing position (see Figure 1.5.-
1.)
WARNING!
The appliance must be transported, handled or stored in a vertical
position and it must not be inclined more than 45° (Figure 1.5.-2.). This
appliance is very heavy, it needs to be carried by 2 or more persons,
otherwise it might cause personal injury or appliance damage. If during any
of the operations above, the placement of the appliance needs to be different
from the recommended position, before the first start up of the appliance,
please wait at least 3 hours starting from the time when the appliance has
been put into the proper vertical position and / or into operation. This way, it
is ensured that the lubricating oil working within the cooling circuit is placed
properly and compressor damage is avoided.
The packaged appliance can be handled by hand or by lift truck –
please follow the instructions printed on the carton box.
It is recommended to keep the appliance in the original packaging until it is
installed on the selected place, if possible, especially when construction work
is performed on the site.
1 item
1 item
3 items
1 item
1 item
Figure 1.5.-1.