Publicité
Les langues disponibles
Les langues disponibles
SilverCrest SPWE 180 A2
7. Getting started
7.1 Switching on the scales / measuring weight
Due to the Step-On-Power function, the bathroom scales are switched on automatically when you
step on the tread (2) and they start to measure your weight immediately.
To change the unit of weight, press the "Button for Setting the Weight Unit" (3). The selected unit of
weight is then indicated on the LCD display (1).
Stand on the tread (2) of the bathroom scales so that your weight is evenly distributed. Remain as
still as possible during the weighing process as the measurement result may be distorted otherwise.
The measurement result is indicated on the LCD display (1) during the weighing process. The
measurement is complete when the display flashes three times.
8 - English
The bathroom scales must be calibrated before first use or after having been
moved to ensure that they can determine one's weight exactly. To do so, step
briefly on to the tread (2), step off it again and wait until the bathroom scales
switch off automatically. The bathroom scales are now calibrated.
A solid surface is required to measure weight correctly. Thus always place
the bathroom scales on a solid, horizontal floor covering and never on
carpet. This can distort the measurement result.
To obtain comparable measurement results, you should always weigh
yourself if possible at the same time of day (preferably in the morning).
Always weigh yourself if possible under the same conditions: on an empty
stomach, after having gone to the toilet and naked.
Please note that values for the stone unit of weight are not represented as
decimal values. The display is divided into two segments by a colon. Only
whole numbers are displayed in the "st" unit of weight to the left of the colon.
The remaining weight is displayed in the "lb" unit of weight to the right of the
colon.
Example: "6: 8.0 st" is shown on the display. This corresponds to 6 st and 8
lb.
Publicité
