Vacuum Cycle For Cooking - Fulgor Milano FVCD 270 Mode D'emploi Et D'entretien

VACUUM CYClE FOR COOkING

Once the pack has been prepared inside the vacuum chamber as described in the "Preparation"
chapter, close the lid exerting a slight pressure on the front and at the same time select the
key. The cooking vacuum cycle is started.
An acoustic signal (short beep) is emitted on cycle start.
The cycle proceeds automatically in the following order:
The evacuation phase is signalled by the luminous indicator of the
The sealing phase is signalled by the luminous indicator key
During the successive unload phase, all of the luminous indicators go back to initial switch-on situation.
• When the vacuum chamber is decompressed, it is possible to open the lid and extract the sealed bag.
• As in the case of the preservation vacuum cycle, in the cooking vacuum cycle the product is tightly
wrapped and compressed by the bag.
• An acoustic signal (short beep) is emitted at the end of the cycle, indicating that the machine is
ready for a new cycle.
By pressing the
the sealing phase in advance.
54
key during the air evacuation phase, the appliance passes to
Instructions for Use
key flashing.
on.
FVCD 270