Functioning; Switch-On; Vacuum Cycle For Preservation - Fulgor Milano FVCD 270 Mode D'emploi Et D'entretien

SWITCH-ON

• After three minutes of inactivity, the machine enters the energy-saving state. To exit the energy-
saving state, press any key.

VACUUM CYClE FOR PRESERVATION

Once the pack has been prepared inside the vacuum chamber as described in the "Preparation"
chapter, close the lid exerting a slight pressure on the front and at the same time select the
key . The preservation vacuum cycle is started.
An acoustic signal (short beep) is emitted on cycle start.
52

FUNCTIONING

Instructions for Use
FVCD 270