Publicité
Les langues disponibles
Les langues disponibles
Main parts of the product
(Fig.1 on page 4)
1. Lid
2. Soup/food pan
3. Water pot
4. Housing
Remark: The content of this manual applies for all listed items
unless specified otherwise. The appearance may vary from the
shown illustrations.
Control panel
(Fig.2 on page 5)
5. ON/OFF button
6. Display panel
7. Up button
8. Down button
9. Temperature setting button
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all accesso-
ries. In case of incomplete or damaged delivery, please contact
the supplier immediately. In this case, do not use the device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
1. Fill the water pot above MIN mark and below MAX mark
2. Fill the soup/food pan, for soup kettle not over the MAX mark.
3. Connect the appliance to power supply. One beep sound will
be heard.
4. Enter to preparation mode by pressing the ON/OFF button,
the display panel shows the last setting temperature.
5. Press "Up" or "Down" button, the appliance is heating (heat-
ing mode). The upper row of display panel shows the current
water temperature, the lower row shows operating time -
00:00 (hours : minutes).
6. Adjust the set temperature by pressing "Temperature set-
ting" button, display shows last set temperature. Press "Up"
or "Down" button to adjust the temperature by 1°C interval.
7. The temperature will be set automatically after 3s and return
to heating mode.
NOTE:
- Fill the preheated soup/food only.
- Default temperature setting at the first time is 85°C.
- Under temperature setting mode, press and hold "Up" or
"Down" button for 3s to adjust the temperature rapidly by
1°C interval.
- Press ON/OFF button for 3s to turn off the appliance.
Compensation setting
1. In preparation mode, press and hold "Up" and "Down" buttons
at the same time for 3s to enter temperature compensation
mode.
2. The upper row of display panel shows the current compensa-
tion value, the lower row shows "COMP".
3. Press "Up" or "Down" button to adjust the value by 1°C in-
terval.
4. The temperature will be set automatically after 3s and return
to preparation mode.
NOTE:
- Default compensation temperature at the first time is 0.
- The compensation range is -10°C to 10°C.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Clean the inside of container with a non-abrasive detergent
and rinse with clean water.
• Clean and descale the boiler base at regular intervals (see
chapter "Descaling")
• No parts are dishwasher safe.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
GB
9
Publicité
