Publicité
Les langues disponibles
Les langues disponibles
Requirements
The eBike can then only be switched on when the fol-
lowing requirements are met:
– A sufficiently charged eBike battery is inserted (see
operating instructions for the eBike battery from
the system generation the smart system).
– The speed sensor is connected properly (see oper-
ating instructions for the drive unit from the system
generation the smart system).
Before initial commissioning
Prior to initial start-up, remove the protective
u
film from the display to guarantee that the on-
board computer is fully functional. If the protec-
tive film remains on the display, this can impact the
functionality/performance of the on-board com-
puter.
Before setting off, make sure that you can easily
reach the buttons on the operating unit. It is recom-
mended to align the plus/minus buttons level so that
it is almost perpendicular to the ground.
To align the Purion 200 operating unit, gently loosen
the fastening screw (8) of the holder (7) until it can
be turned on the handlebars. Align the operating unit
and carefully retighten the fastening screw (8).
Control unit power supply
If a sufficiently charged eBike battery is inserted into
the eBike and the eBike is switched on, the internal
battery of the operating unit is powered and charged.
If the state of charge of the internal battery of the op-
erating unit is very low, you can charge it via the diag-
nostics connection (9) with a USB Type-C® cable us-
ing a power bank or another suitable power source
(charging voltage 5 V; charging current
max. 600 mA).
Always close the flap of the diagnostics connec-
tion (9) so that no dust or moisture can enter.
Bosch eBike Systems
Operation
Switching the eBike on/off
To switch on the eBike, briefly press the on/off but-
ton (1). The eBike is ready to ride once the start-up
animation is complete.
The display brightness is controlled by the ambient
light sensor (3). Therefore, do not cover the ambient
light sensor (3).
The drive is activated as soon as you start pedaling
(except in the OFF riding mode). The drive power
varies depending on the riding mode set.
As soon as you stop pedaling when in normal opera-
tion, or as soon as you have reached a speed of
20/28 mph, the drive switches off the assistance.
The drive is automatically reactivated as soon you
start pedaling again and the speed is below
20/28 mph.
To switch off the eBike, press the on/off button (1)
briefly (< 3 s).
If no power is requested from the drive for approx.
10 minutes (e.g. due to the eBike being stationary)
and no button is pressed, the eBike switches off auto-
matically.
Operation
The functions of the buttons on the Purion 200 oper-
ating unit can be found in the following overview.
Depending on how long it is pressed for, the select
button has 2 functions.
Scroll to the left
Scroll to the right
English – 9
0 275 U07 3RP | (03.05.2024)
Publicité
