Hilti VC 300-17 X Mode D'emploi page 22

5.3 Fitting/changing the plastic dust bag
1. Disconnect the supply cord plug from the power outlet.
2. Open the two catches.
3. Lift the vacuum cleaner top section away from the waste material container.
4. Use a cable tie to close the plastic dust bag below the punched holes.
5. Remove the plastic dust bag.
6. Clean the waste material container with a cloth.
7. Fit a new plastic dust bag (see instructions printed on it) in the waste material container.
8. Fit the vacuum cleaner top section onto the waste material container and close the two catches.
6 Operation
WARNING
Risk of injury. Damage to the filter system may allow harmful dust (health hazard) to escape.
▶ In an emergency (e.g. filter ruptured), switch the vacuum cleaner off, unplug the supply cord from
the power outlet and have the vacuum cleaner checked by a trained and qualified person before
further use.
CAUTION
Risk of injury presented by the appliance running away out of control. The vacuum cleaner may
run away out of control if the wheel brakes are not engaged.
▶ Engage the wheel brakes so that the vacuum cleaner stands securely.
6.1 Picking up dry dust
Note
Before picking up dry dust, especially dust from mineral materials, always check to ensure that the
correct dust bag is fitted in the container. The material picked up by the vacuum cleaner can then be
disposed of cleanly and easily.
CAUTION
Risk of injury. Hazardous material that has been picked up may escape if a filter element is not used.
▶ Never use the appliance without a filter element.
▶ Check that the filter element is dry and that the correct type of dust bag is fitted.
6.2 Picking up liquids
CAUTION
Risk of injury. Hazardous material that has been picked up may escape if a filter element is not used.
▶ Never use the appliance without a filter element.
1. Check the container level monitoring system. → page 20
2. If possible, use a separate filter element for wet applications.
3. After picking up liquids, open the two catches.
4. Lift the vacuum cleaner top section away from the waste material container and place it on a level surface
so that the filter element can dry.
5. Empty the waste material container and use a water hose to rinse it out. Use a brush to clean the
electrodes and clean the filter element, after allowing it to dry, by wiping it off with your hand.
6. Allow the waste material container to dry.
6.3 After use of the vacuum cleaner
1. Switch off the electric tool.
2. To switch the appliance off, turn the control switch to the
3. Unplug the vacuum cleaner's supply cord from the power outlet.
18 English
Printed: 04.09.2017 | Doc-Nr: PUB / 5372310 / 000 / 01
3
position.