SilverCrest SSMZ 300 A1 Mode D'emploi page 12

• In order to separate the two juicer
cones 10+11 again, press the small
ridges inwards and upwards out of the
recesses.
11
7.2 Assembling the citrus
press
DANGER!
Only plug the mains plug 3 into the
wall socket after the device has been
completely assembled.
1. Place the base unit 4 on a dry, solid
and level surface.
Figure A:
2. Place the citrus press attachment 5 onto
the base unit 4 in such a way that the
two citrus press symbols
up.
NOTE: you can lift off the entire citrus press
attachment 5, complete with drive axle 7
and cover ring 6, and replace it again.
These two parts can be removed e.g. for
cleaning.
10 GB
3. Insert the cover ring 6 and the drive ax-
le 7 if necessary.
10
4. Place the juice container 8 into the cit-
rus press attachment 5.
5. Place the screen 9 into the juice con-
tainer 8. The small grooves in the mid-
dle of the screen need to fit onto the
ridges on the juice container.
6. Place the small juicer cone 10 or the
assembled juicer cones 10+11 onto
the drive axle 7.
7. Insert the mains plug 3 into a wall
socket corresponding to the technical
data.
7.3 Drip stopper
Figure D: the outflow 2 of the juice con-
tainer 8 has an integrated drip stopper func-
tion. If you want to remove or replace the
container under the outflow, you can close
are lined
the drip stopper to prevent juice from drip-
ping out.
NOTE: ensure that the drip stopper is open
during juicing, so that the juice does not col-
lect in the juice container 8.
• To close the drip stopper, gently press
the outflow 2 upwards.
• To open the drip stopper, gently press
the outflow 2 downwards.
7
6