3M Protecta Viper 2 Manuel D'instruction page 8

;
Before using this equipment, record the product identification information (see Figure 12) in the "Inspection and
Maintenance Log" Table 2 at the back of this manual.
PRODUCT DESCRIPTION
fall arrest device which is to be used only with approved vertical anchor lifelines and approved lanyards. Together, the fall
arrester, with the vertical lifeline and lanyard, is intended to be used as part of a personal fall arrest or restraint system.
;
Fall Arrest only: This equipment is suitable only for Fall Arrest purposes. This equipment is not suitable for Fall
Restraint, Work Positioning or any other purposes. Contact 3M Fall Protection with any questions.
C Rope Length; G Counterweight.
Figure 1 Description:
Figure 2 illustrates components of the Rope Grab. See Table 1 for Component Specifications.
Model Description
5009036 (AC400) Protecta
5009038 (AC401) Protecta
COMPONENT SPECIFICATIONS
Figure 2 Reference: Description:
A Fixed Cam Axis
B Rotating Flange Axis
C Rotating Flange
D Fixed Flange
E Rotating Cam/Clamp
F Rubber Washer - Fall Indicator
G 3M supplier reference
The arrow on the body must point upwards and in the same direction as the top anchor connection
H
of the rope.
J Carabiner Eye
K Lashing Cable 1,5 mm (0,06 in)
L Carabiner AJ514/01
M Extension Strap
N Carabiner Hook 20LF - 9509437
P 10,5 mm (0,41 in) Rope Lifeline
Materials:
Body Component:
Carabines:
Hooks:
Ropes:
Webbing:
Figure 1 illustrates the 3M™ Protecta
Table 1: Protecta® Viper™ 2 Rope Grab and Rope
Viper™ 2 Rope Grab with Carabiner
®
Viper™ 2 Rope Grab with Carabiner
®
Stainless Steel, Steel, Aluminum Alloy, and Rubber
Steel - 22 kN (4 946 lb) Minimum Tensile Strength
Alloy Steel, Aluminium, Zinc Plated - 22 kN (4 946 lb) Minimum Tensile Strength
Nylon - 25 kN (5 620 lb) Tensile Strength
Nylon - 22 kN (4 946 lb) Tensile Strength
Viper™ 2 Rope Grab Fall Arrester. The Rope Grab is a
®
Lifeline Requirements
For use with 10,5 mm (0,41 in) diameter
Kernmantle type Rope
8