Parkside PPS 40 C3 Consignes D'utilisation Et De Sécurité page 20

ATTENTION!
fTo unscrew the electrode, do not apply
irregular pressure, gradually increase
pressure until the electrode comes out.
Then screw the new electrode into the
holder.
„
The burner sleeve
the central bore is damaged or if it has
expanded in comparison to the bore of a
new nozzle. If the electrode
8c
burner sleeve
this can result in the parts overheating.
Once replaced, make sure the nozzle
clamping sleeve
sufficiently.
ATTENTION!
fThe nozzle clamp sleeve
be screwed on to the burner
has been fitted with the electrode
8c
burner sleeve
fIf these parts are missing,
the device may malfunction and
it may create a hazard for the
operating personnel.
• Maintenance
PLEASE NOTE!
fThe plasma cutter must be regularly
maintained for perfect function and to
comply with the safety requirements.
Improper and wrong operation may
cause failures and damage to the
device. Repairs must only be carried out
by qualified specialists.
20 GB/IE/NI/CY/MT
8c
must be replaced if
8d or the
are replaced too late,
8b is tightened
8b
must only
8
once it
8d
.
PLEASE NOTE!
fIt is not necessary to empty the conden-
sation water container
collects here then fine droplets will form
under the container. The condensation
water is then dissipated through
evaporation.
Switch off the main power supply and the
main switch of the device prior to carrying
out maintenance or repair work on the
plasma cutter.
„
Regularly clean the outside of the
plasma cutter and its accessories. Use
compressed air, cotton waste or a brush
to remove dirt and dust.
„
In case of a defect or a necessary
replacement of equipment parts, please
contact the appropriate qualified
personnel.
• Storage
and
If you will not be using the device for a
while, protect it from dust by storing it in
a clean and dry place.
• Information about recycling
and disposal
DO NOT DISPOSE OF ELECTRICAL
TOOLS IN HOUSEHOLD WASTE!
DON'T THROW AWAY – RECYCLE!
According to European Directive
2012/19/EU, used electrical devices must
be collected separately for environmentally
compatible recycling or recovery. The
symbol of the crossed out dustbin means that
this device must not be disposed of in
household waste at the end of its service life.
18
. If water