Publicité
Les langues disponibles
Les langues disponibles
The flying sparks, hot metal
as well as hot objects and hot
device equipment can cause
fires or burns. Check the working
environment and make sure the
workplace is suitable prior to
using the device.
„
Remove all flammable material
within 10 m of the plasma
cutter. If this is not possible,
cover the objects meticulously
using suitable covers.
„
Do not make cuts in places
where flying sparks could
come into contact with
flammable material.
„
Protect yourself and others
from flying sparks and hot
metal.
„
Please be careful because
sparks and hot materials can
easily fall through small gaps
and openings while cutting
and land on adjacent areas.
„
Please be aware that cutting on
a ceiling, floor or a partition
can cause a fire on the
opposite side that is not visible.
„
Connect the power cable using
the shortest route with a socket
situated close to the workplace
to prevent the power cable
from being spread across the
whole room and located on a
surface which could cause an
electric shock, sparks or fire
outbreak.
10
GB/IE/NI/CY/MT
„
Do not use the plasma cutter to
defrost frozen pipes.
Risk of electric shock:
WARNING!
f Electric shock from the cutting
electrode can be fatal.
„
Do not use the plasma cutter
when it is raining or snowing.
„
Wear dry insulating gloves.
„
Do not touch the electrodes
with bare hands.
„
Do not wear wet or damaged
gloves.
„
Protect yourself from electric
shock with insulation against
the workpiece.
„
Do not open the device
housing.
„
Additional protection against
a shock from the mains
power in the event a fault
can be provided by using a
fault-circuit interrupter, which
is operated with a leakage
current of no more than 30 mA
and covers all mains-powered
devices in close proximity. The
fault-circuit interrupter must be
suitable for all types of current.
„
There must be means of rapid
electrical isolation of the
cutting power source or the
cutting circuit (e.g. emergency
Publicité
