Parkside Performance PABSP 20 LI C3 Instructions D'utilisation Et Consignes De Sécurité page 49

In particular clean the air vents after every
use with a cloth and soft brush.
The vents must always be clear.
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be
harmful to its surfaces.
˜ Maintenance
Before and after each use, check the product
and accessories (e.g. accessory tools) for
wear and damage. If required, exchange
them for new ones as described in this
instruction manual. Observe the technical
requirements (see "Technical data").
˜ Repair
This product does not contain any parts that can
be repaired by the user. Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired.
˜ Storage
Push the rotation direction switch
centre position to lock the on/off switch
Clean the product as described above.
Store the product and its accessories in a
dark, dry, frost-free, well-ventilated place.
Always store the product in a place that is
inaccessible to children. The ideal long term
storage (longer than 3 months) temperature is
between +20 and +26 °C.
Guide the drill bit into the bit holder
Store the product in its carrying case
Battery pack advice
Only store the battery pack
charged. The battery pack should be charged
to 40 to 60 % (red and orange LED in the
charge indicator
[
for extended periods.
Check the battery pack
every 3 months when storing for extended
periods. Recharge as necessary.
48 GB/IE
to the
[ 5 ]
[ 6 ]
.
8 ] [
.
[ ]
partially
[ ]
light up) before storing
]
charge about
[ ]
˜ Transportation
Push the rotation direction switch
centre position to lock the on/off switch
Transport the product in its carrying case
Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles.
Secure the product to prevent it from slipping
or falling over.
˜ Disposal
Before passing on, disposing of or returning
the product to the manufacturer, make sure
that all data has been deleted from the
product and the cloud.
To do this, refer to the chapter:
"Additional functions", menu point:
{Disconnect and wipe
Packaging:
The packaging is made of environmentally
friendly materials, which may be disposed of
through your local recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
.
are marked with abbreviations (a)
and numbers (b) with following
meaning: 1–7: plastics/20–22: paper
and fibreboard/80–98: composite
materials.
Product:
The product incl. accessories and packaging
materials are recyclable and are subject to
extended producer responsibility.
Dispose them separately, following the illustrated
Info-tri (sorting information), for better waste
treatment.
The Triman logo is valid in France only.
to the
5 ] [
.
6 ] [
.
[ ]
data}`