Charge the battery pack
when it is at medium or low charging level.
The charging control LEDs (green
red
) indicate the status of the charger
[
]
and the battery pack
LED
Red LED lights up
Green LED lights up
Green and red LED
flashing
Red LED flashing
Green LED lights up
(without battery pack)
Insert the battery pack
charger
.
[
]
Connect the power cord with power plug
of the charger
to the socket.
[
]
When the battery pack
charged: Remove the battery pack from
the charger
. Then disconnect the power
[
]
plug
of the charger from the socket.
[
]
˜ Attaching/removing the
accessory tool
m
CAUTION! RISK OF INJURY!
Accessory tools can be sharp and
may become hot during use. Always
wear protective gloves when handling
accessory tools!
m
WARNING!
Always switch the product off, remove
the battery pack
product cool down before making any
adjustments!
m
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
tool when the product is in operation.
before operation
[
]
and
[
]
[
:
[
]
Status
Battery pack
charges
Battery pack fully
charged
Battery pack
defective
Battery pack too
cold or too warm
Charger ready
into the
[
]
[
is fully
[
]
and let the
[
]
m
CAUTION! RISK OF INJURY!
After the product has been switched off, the
u
accessory tool continues moving for some
]
time. Do not touch the accessory tool and
do not attempt to brake it.
This product is equipped with an automatic
spindle lock to open or close the chuck
the chuck ring
.
[
2 ]
Open the chuck
a counter-clockwise direction (Fig. E).
Insert a suitable accessory tool into the
chuck
as deep as required.
1 ]
[
Close the chuck
tool in position. Turn the chuck ring
clockwise direction.
NOTES
This product is equipped with a Röhm drill
u
chuck with an anti-lock function.
]
If you attempt to open the fully opened
u
chuck
further, the anti-lock function will
[
1 ]
be activated to protect the chuck.
When the anti-lock function is activated,
u
the chuck
[
1 ]
the chuck ring
A ratcheting sound will be produced when
you attempt to close the chuck.
Deactivating the chuck's
u
function: Turn the chuck ring
clockwise direction by a certain extent.
Then, turn the chuck ring
quickly in a counter-clockwise direction.
Repeat this action if the anti-lock function
is still active. When the anti-lock function is
deactivated, you should be able to close
the chuck
[
1 ]
˜ Trial run
NOTE
Always carry out a no-load trial run before
u
starting work and after every accessory
tool replacement. Switch the product off
immediately if the accessory tool is not
running smoothly, if considerable vibration
occurs or if you hear abnormal noises.
[
1 ]
: Turn the chuck ring
1 ]
[
: Hold the accessory
1 ]
[
[
2 ]
cannot be closed by turning
in a clockwise direction.
[
2 ]
anti-lock
1 ]
[
in a
2 ]
[
suddenly and
2 ]
[
without ratcheting sounds.
GB/IE
with
in
2 ]
[
in a
41