Parkside Performance PABSP 20 LI C3 Instructions D'utilisation Et Consignes De Sécurité page 48

˜ Reconnecting the cordless drill
m IMPORTANT!
If the connection status LED
u
alternatively between 1× and 5×
per second, it means the connection
was disrupted. One of the reasons is
disconnecting the battery pack from the
cordless drill during firmware update. The
cordless drill will not be usable until you
re-established the connection it.
Proceed as follows to re-establish the connection
with the cordless drill:
1. Attach the battery pack to the cordless drill.
2. Press the on/off switch
status LED flashes alternatively 1× or 5×
[ ]
per second.
3. Enable Bluetooth on your mobile product.
4. Press and hold the
level) on the smart battery pack for 3 seconds
to ensure that Bluetooth is activated on the
battery pack.
5. Connect the battery pack to the Lidl Home
app following the chapter "Connecting the
product to the Lidl Home app".
{Device info}
6. Select
"PABSP 20 Li C3 (2201)" under {Battery}.
The overview page of the cordless drill is
displayed.
{Firmware
7. Select
firmware.
8. After successfully updating the firmware, the
connection with the cordless drill should be
re-established and the cordless ready for use.
˜ Reset to factory original
setting
{Reset}
Select to restore the firmware to
o
original factory setting.
flashes
[ ]
. The connection
6 ] [
button (charging
version}
and update the
˜ Privacy policy
You can find the complete data protection
guideline under the tab
guideline}.
˜ Disconnecting the product and
deleting data from the app
1. In the tab, select the product that you
want to remove and whose data you want to
delete.
2. Select the icon in the top right.
{Remove device}.
3. Select
4. To delete the data, select
delete data}. If you just want to disconnect
the product without deleting the data, select
{Disconnect}.
˜ Problems with the app ‒ FAQ
1. Select the battery pack you have questions
about from the product list.
2. Select the icon in the top right.
{Other}
3. Under select the option
(= frequently asked questions).
˜ Cleaning and care
WARNING!
m
Always switch the product off, remove
the battery pack
product cool down before performing
inspection, maintenance and cleaning
work!
˜ Cleaning
Never allow fluids to get into the product.
The product must always be kept clean, dry
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
safe use and prolong the life of the product.
Clean the product with a dry cloth. Use a soft
brush for areas that are hard to reach.
{Data protection
{Disconnect and
{FAQ}
and let the
[ ]
GB/IE 47