Parkside Performance PABSP 20 LI C3 Instructions D'utilisation Et Consignes De Sécurité page 43

Before operating the product, check whether
the accessory tool is correctly positioned, i.e.
centred in the chuck
Screw bits are labelled according to their
dimensions and their shape. If you are
uncertain, always check whether the bit fits
tightly in the screw head without any free
play.
˜ Operation
˜ Gear selection
ATTENTION! RISK OF PRODUCT
m
DAMAGE!
Do not operate the gear selector
until the product has come to a
standstill.
Change the gear by sliding the gear
selector forwards or backwards (fig. F).
4 ] [
1 gear:
st
Suitable for:
Speed:
Torque:
2 gear:
nd
Suitable for:
Speed:
Torque:
˜ Setting the rotating direction
m ATTENTION! RISK OF PRODUCT
DAMAGE!
Do not operate the rotation direction
switch until the product has come to
5 ] [
a standstill.
Change the direction of rotation by pressing
the rotation direction switch
left or right (fig. G).
When the rotation direction switch
the middle position, the on/off switch
locked.
42 GB/IE
.
1 ] [
4 ] [
Screwing
Low
High
Drilling
High
Low
towards the
[ 5 ]
is in
[ 5 ]
is
6 ] [
˜ Torque control
This product is equipped with a torque control that
disengages the spindle when a predefined torque
is exceeded.
The torque can be adjusted by turning the
torque sleeve (fig. H).
3 ] [
Small screws or soft materials: Select a low
level.
Large screws, hard materials or removing
screws: Select a high level.
For drilling operation: Turn the torque
sleeve to the
[ 3 ]
˜ Switching on and off
NOTE
The on/off switch
6 ] [
Switching on: Press and hold the on/off
switch .
[ 6 ]
Regulate the speed as required (see "Speed
control") (fig. I).
Switching off: Release the on/off
switch .
[ 6 ]
˜ Speed control
By using the on/off switch
progressively control the speed:
Pressure
Gentle pressure:
Greater pressure:
˜ LED work light
This product is equipped with a LED work light
to illuminate the immediate working area to
improve visibility in poorly lit areas.
The LED work light
as soon as the product is switched on.
NOTE
The LED work light
u
additional approx. 10 seconds after
switching off the product.
position.
cannot be locked.
, you can
6 ] [
Speed
Lower speed
Higher speed
lights up automatically
[ ]
stays on for an
[ ]
[ ]