Publicité
2.1.
SPECIFICATIONS ACCORDING TO THE MODEL
2.1.1.
MONZA
The stove Monza has on the top two rings to be used as a plate warmer. These rings
should be handled with the accessory included for this purpose (see drawing D2.27 and
D2.28).
The worktop has in both sides two removable handles made in stainless steel.
The model Vitro has another handle in the front of the worktop.
2.1.2.
SENA PLUS
The ceiling of this stove model is supported
on the top of the stove and positioned on
4 supports (2 front and 2 rear). Therefore,
when moving or installing the stove, you can
remove the ceiling of the stove to reduce the
weight, and therefore facilitate operation. Once
positioned in the desired location, and before
laying the smoke pipe, you must reposition the
ceiling. (see drawing D2.29)
2.1.3.
ORDESA
Inside of the combustion chamber you can find a piece called "ash catcher". This piece is useful to avoid the fall of the ashes to the floor
when you open the door of the stove. To place it properly, follow the next steps:
1.
We must match the hooks of the piece with the groove of the stove. To this, rotate slightly the piece.
When the piece is inserted on the grooves, drop it from its own weight to rest in his final position (see drawing D2.30).
2.
In the stove, it is included a handle to remove the ash pan to avoid burns (see drawing D2.31).
D2.30
2.1.4.
ETNA AND DERBY 14
The models Etna and Derby 14 have a door on the right side whose function is to load fuel (see drawing D2.32).
In the Etna stove, it is included a handle to remove the ash pan which is hidden behind the lower door (see drawing D2.33).
In the model Etna the handle of the side door is type "cold hands", it is advisable to remove the handle in order to avoid its heating and
deterioration.
D2.32
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
24
D2.28
D2.27
D2.29
D2.31
D2.33
STOVES
Publicité
