Publicité
1.
GENERAL WARNINGS
The installation of a stove must be done according to the local, national or European regulations.
Our liability is limited to the supply of the equipment. The installation must be done according to the procedures expected for this
kind of equipments, according to the indications included in this manual and the rules of the profession. The fitters must be qualified,
with official license and they will work for enterprises that accept responsibility of the installation.
In the case of devices with turbine, it must be connected to a 230V - 50Hz - IP20 approved power outlet.
Bronpi Calefacción, S.L. will not be responsible for the modifications made to the original product without the prior written permission as well
as for the use of non-genuine spare parts or pieces.
This stove can be used by children aged from 8 years and by persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge whenever they have supervision or they have received instruction concerning the use of the stove in a safe way
and understand the hazards involved. Children must not play with the stove. Cleaning and user maintenance shall not be made by children
without supervision.
IMPORTANT! This product includes a spray paint can inside the combustion chamber or oven (when applicable) which
must be removed before the ignition.
2.
GENERAL DESCRIPTION
The equipment that you have purchased contains the following pieces:
-
Stove body placed on the pallet.
-
Inside the combustion chamber you can find: a box/bag with a thermal glove that allows us to handle the air controls, draft-diverter
valve, door, etc, in order to avoid burns. One spray paint can to repair possible scratches. The smoke baffle-plate (according to the
models).
The equipment is made of several elements of steel sheets welded, with different thickness, and, depending on the model, pieces of cast
iron or vermiculite (refractory material that covers the walls). It also has a panoramic door with vitro ceramic glass (resistant up to 750ºC) and
ceramic cord for the air tightness of the combustion chamber.
Heating is produced by:
a.
Convection: because the air passes through the double hood, the stove gives off heat.
Radiation: through the vitro ceramic glass and the body the heat is irradiated towards the environment.
b.
c.
Forced convection (only models with turbine): thanks to the turbine located at the bottom of the appliance, the air is sucked at room
temperature and returned to the room at a higher temperature.
The models have some settings for a perfect combustion control:
D2.1
D2.2
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
The primary air intake controls the air that passes through the ash pan and
the grate towards the fuel. The primary air is necessary for the combustion
process.
The ash pan should be emptied frequently so that the ash does not block the
primary air intake for the combustion. Also, the primary air rekindles the fire.
-
the door. This control is placed on the left and the movement is from inside to
outside and vice versa. The operation to outside means a greater entry of air
(see drawing D2.1).
-
the primary air regulation is located at the bottom under the door and its
movement is performed from left to right. The right side right implies greater air intake,
-
On the Bombay series and Dover models, this regulation is located under the door. It corresponds
to the regulation located on the right and its movement is made from left to right. The largest air inlet
corresponds when the adjustment is turned to the right, while to the left corresponds the smallest air inlet
(see drawing D2.2).
In all the other models, the control is placed at the bottom of the door or at the ash pan (see drawing
-
D2.3, D2.4 and D2.5).
The models Preston, Derby and Bury have this air intake control under
On the models Croacia, Versalles, Gijón, Gijón-H, Lerma and Lerma-H,
D2.3
20
D2.4
D2.5
STOVES
Publicité
