Publicité
Due to safety reasons during the transport, in some models, the baffle plate is not assembled. You will find it inside the combustion chamber.
To place it properly, follow the next steps:
Frontal models:
D2.11
In the Dover model, the deflector rests on the side pieces of
vermiculite that are inside the combustion chamber and we
must also fit it with the slot where the air comes out of the double
combustion.(see drawing D2.13).
NOTE: some models with oven does not have a baffle plate.
D2.14
Oven
Some models include on the top of the stove an oven with a hermetic firing
chamber. The base of the oven is made of refractory brick (it absorbs heat
and irradiates it). Heating is produced when the smoke passes through the
walls of the oven. On the roof of the oven there is one pipe that connects the
cooking chamber with the smoke outlet in order to remove the gas generated
inside the oven.
The oven has the following components:
-
Thermometer it is disassembled. To install it, it is necessary to
introduce the sheath through the hole of the door and, then, put the nut (see drawing D2.15).
-
NOTE: Tudela model includes a bimetallic thermometer placed on the glass of the oven. To install it, it is necessary to introduce the
thermometer through the hole of the door and, then, put the rubber and the nut on the backside (see drawing D2.16).
WARNING!! The thermometer shows the cooking temperature of the oven, it never shows the combustion chamber
temperature.
The maximum cooking temperature for the oven is 200-230ºC. If the thermometer shows that the oven reaches a higher temperature, this
means that the equipment has been overloaded and this will invalidate the warranty.
-
Tray. It is made of stainless steel. The tray must not come into contact with food. It can be adjustable in different levels according to the
slot that we use. In order to avoid the damage of the tray, it is recommended to extract it outside the oven when it is not being used.
There are some models that, due to the measures of the oven, it is not possible to place this tray and, therefore, they are not included
such as models Tudela, Lerma-H and Gijón-H (except if optionally the Inox Kit is purchased for this model, where it would include the
tray).
-
Refractory bricks or ceramic pieces. They are placed on the base of the oven. Their purpose is to absorb heat and irradiate it.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D2.12
Roasting grille
Some stoves includes a roasting grille as an accessory (see drawing D2.14).
In order to avoid the damage of the roasting grille, it is recommended to
extract it outside when it is not being used.
The models Dover, Bombay series, Etna, Ordesa, Bremen, Preston, Derby,
Bury and Altea do not include this grille.
In the models Croacia, Versalles, Sena Plus, Gijón, Gijón-H, Lerma and
Lerma-H, this grill is adjustable in two heights depending on the slot of the
lateral guide that you use.
22
Corner models :
D2.13
D2.15
D2.16
STOVES
Publicité
