ULTIMATE SPEED USML 3.7 B2 Mode D'emploi page 25

˜ Process steps and indicators
The following table shows the different process steps and the related indicators:
Process step
Mains plug connected to
[ 1 ]
mains socket
Before product is connected
to car
Type 2 plug connected to
[ 13 ]
the car and check completed
successfully
Charging approved on
vehicle, charging process
starts
Charging completed
shows STANDBY: Confirm again in the vehicle control .
* If the display
4 ] [
˜ Troubleshooting and display error codes
Problem
The product does not
work .
LED colour
3 ] [
green (2 seconds)
blue
yellow
flashing green
green
Possible cause
The mains plug is not connected to the
1 ] [
mains socket .
Display
[ 4 ]
ULTIMATE SPEED
o
PLEASE CONNECT TO THE CAR
o
indicator (white)
10 ] [
o
STANDBY *
o
indicator (flashing white and green)
[ 10 ]
o
Actual charging voltage
o
Temperature
[ 7 ]
o
Max . charging current
o
Charging time
9 ] [
o
Actual charging current
o
indicator (green)
10 ] [
o
Actual charging voltage
o
Temperature
7 ] [
o
Max . charging current
o
Charging time
9 ] [
o
Actual charging current
o
Solution
Connect the mains plug
to the mains socket .
6 ] [
8 ] [
11 ] [
6 ] [
8 ] [
11 ] [
1 ] [
GB/IE 25