Publicité
Les langues disponibles
Les langues disponibles
˜ First set-up of the product
˜ Unpacking the product
INFO: Observe the user manual for the
vehicle .
1 . Take the product out of the packaging and
remove all packaging materials and plastic
wrappings .
2 . Check to make sure that all listed parts are
included (see "Scope of delivery") .
3 . Check whether the product and all parts are
in good condition, if any damage or defect is
detected, do not use the product, but follow the
procedure described in chapter "Warranty" .
˜ Operation
˜ Starting the charging process
(Fig . C)
INFO:
Before operation, the product carries out
o
an automatic self test and checks internal
components, possible residual currents, over or
under voltage and temperature . The charging
process is only possible if all test criteria is
being met .
The charging time depends on the following
o
factors:
–
Vehicle battery capacity
–
Vehicle battery charging status
–
Mains socket capacity
Monitor the charging process during charging:
o
–
via the vehicle dashboard
–
via the display
4 ]
[
For most vehicles, the charging capacity (kWh)
o
is displayed .
The type 2 plug
13 ]
[
o
locked once the charging process starts .
1 . Switch off the engine of the vehicle .
2 . Take out the product from the storage bag
3 . Unwind the charging cable
24 GB/IE
may be automatically
5 ]
[
.
14 ]
[
4 . Connect the mains plug
socket .
5 . Open the charging port of the vehicle .
6 . Remove the cover cap
type 2 plug
[
13 ]
7 . Connect the type 2 plug
the vehicle .
8 . Confirm on your vehicle to start the charging
process .
9 . The charging process begins .
˜ Finishing the charging process
INFO:
The charging process stops automatically after
o
the charging time that was set in the vehicle .
If the type 2 plug
o
the charging process: The locking of the
type 2 plug will automatically be released
once the charging process is completed .
After charging: Wind up the charging
o
cable
. Do not kink the charging cable .
14 ]
[
1 . Disconnect the type 2 plug
of the vehicle .
2 . Place the cover cap
3 . Close the charging port of the vehicle .
4 . Disconnect the mains plug
socket .
.
to the mains
1 ]
[
of the
12 ]
[
.
with the socket of
[
13 ]
was locked during
13 ]
[
from the socket
13 ]
[
on the type 2 plug
[
12 ]
from the mains
1 ]
[
.
13 ]
[
Publicité
