Grundig P25-449/12 Manuel D'utilisation page 18

Tuning to stations with the
remote control
Station programming (assigning TV pro-
grammes to station positions) as described
on pages 14-15 can also be performed with
the remote control...
— by directly entering the channel numbers
Example:
The third programme is broadcasted on
channel 59 and you wish to assign it to sta-
tion position 3.
@ Selecting station position 3 with the re-
mote control
— Press button 3 of the group of buttons [A].
@ Selecting the channel mode with the re-
mote control
— Press button [B].
The display shows C 8) for channel anda
random number.
@ Entering channel 59
— Press buttons 5 and 9 of the group of but-
tons [A] on the remote control.
@ Storing the entered channel number
~ Press button [E].
The channel number will flash.
— Within this time, press button OK of the
group of buttons [D].
— with the station search system
Example:
SAT 1 can be received on one of the spe-
cial channels (S01-S$41).
You wish to assign the programme of this
TV station to station position 6.
@ Selecting the station position 6 with the
remote control
— Press button 6 of the group of buttons [A).
@ Selecting the channel mode with the re-
mote control
— Press button [B] until the display shows
S @ for special channel.
@ Starting the station search with the re-
mote control
— Press button V or A of the group of but-
tons [D] to start the search in downward =
V or in upward direction = A.
The station search stops at each station
which can be received. If the found sta-
tion is not the desired one, start the sta-
tion search again until the desired station
is found.
@ Storing the channel number of SAT 1
— Press button [E] and then button OK of the
group of buttons [D]
The display will show 6 for the selected
station position.
Selecting the code number of the TV
standard using the remote control unit
@ Select the station position and channel
mode as described.
Press the STOP button [E].
Display field flashes.
Within this time press the P/C button [B].
The display shows, eg: n0.
Select the required TV standard (code
number) using the button & or V (group
of buttons [D]) (see p. 14, table "TV stand-
ards").
— This will be shown in the display with n 0
ton 4,
Storing the TV standard
@ Press the P/C button [B
STOP button [E].
— Display field flashes.
@ Within this time press the OK button
(group of buttons [D)).
— The display shows the station position.
and then the