Deactivating The Anti-Theft Warning; Dguard ® Roadbook; Recording A Tour - digades DGUARD Mode D'emploi

OPERATING THE dguard
4.5.4

Deactivating the anti-theft warning

Completely deactivating the anti-theft warning
Observe the following requirement:
• The anti-theft warning is activated in the dguard
Activating the anti-theft warning",
1. Open the dguard
EN
2. In order to deactivate the alarm fully, click on the selection button
"Alarm function".
Ö The anti-theft warning function remains deactivated even when you
switch off your motorbike's ignition.
The anti-theft warning is active and you would like to ride off
1. Switch on your motorbike's ignition.
Ö The LED on the dguard
ed. When the LED on the dguard
system is active and the anti-theft warning is deactivated.
4.6 dguard
You can use the dguard
recorded a tour, the interactive map shows you your route, your speeds
and the altitude data for your tour. You can add comments to your tours
and share them with your friends on social media platforms.
4.6.1

Recording a tour

1. Open the dguard
2. To record a tour, click
Ö The recording bar at the bottom of the screen opens and shows you
your current recording status.
32
SYSTEM
®
app and navigate to "Anti-theft warning".
®
button flashes slowly and the system is start-
®
roadbook
®
app to record your tours in detail. If you have
®
app and click on "dguard
®
.
INFO
Your tours are only recorded when the ignition is
switched on. If you start a recording when the ignition is
switched off, the dguard
is switched on before starting data recording.
app
®
p. 30).
button lights up permanently, the
®
roadbook".
®
system waits until the ignition
®
(Chapter "4.5.2