Installing The Dguard ® Button Without Handlebar Adapter - digades DGUARD Mode D'emploi

8. Ensure that the adhesive surface of the adhesive pad
of impurities.
9. Stick the adhesive pad
10. Press the dguard
bar adapter.
11. Connect the cable with the 3-pin connection X3 to the dguard
(Chapter „3.1 Laying the cable harness", p. 11)
Ö You have installed the dguard
3.2.2 Installing the dguard
If your motorbike does not offer enough space on the handlebar, you can
fix the dguard button to the cockpit without a handlebar adapter.
®
Observe the following requirements at the installation location:
• Select a location on the cockpit with sufficient space for the adhesive
(Fig. 4/3).
pad
1. Clean the selected location in the cockpit thoroughly for the adhesive
(Fig. 4/3)
pad and the dguard
moisture and grease.
2. Ensure that the cable with the 3-pin connection X3 is long enough to
reach the installation location and that your steering movements are
not impaired.
INSTRUCTION
The adhesive surfaces of the adhesive pad
be dry and free of dust and grease. Clean the adhesive
surfaces thoroughly before sticking.
3. Ensure that the adhesive surface of the adhesive pad
of impurities.
4. Stick the adhesive pad
5. Press the dguard
6. Connect the cable with the 3-pin connection X3 to the dguard
(Chapter „3.1 Laying the cable harness", p.
Ö You have installed the dguard
INSTALLING THE dguard
(Fig. 4/3)
to the handlebar adapter.
button against the adhesive surface on the handle-
®
Taster button.
®
button without handlebar adapter
®
button and remove all residue of dust,
®
(Fig. 4/3)
to the selected location.
button against the adhesive surface.
®
button.
®
®
(Fig. 4/3)
(Fig. 4/3)
(Fig. 4/3)
11).
SYSTEM
is free
button
®
EN
must
is free
button
®
15