digades DGUARD Mode D'emploi page 22

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 212
Observe the following requirements:
You have unlocked the dguard
1. Switch on your motorbike's ignition.
Ö The LED on the dguard
When the LED on the dguard
tem is active.
2. Put on your headset.
3. Start the connection process by following the user manual of your
headset.
4. To start the dguard
dguard
button 4 times in quick succession.
®
Ö The LED on the dguard
system automatically tries to establish a connection to your Bluetooth
headset.
Ö If you hear a confirmation tone and the LED on the dguard
flashes 4 times, the connection process was successful. The LED then
remains lit up.
INFO
On some headset models, it is possible to connect sev-
eral devices to the headset via Bluetooth. Depending on
the headset, the dguard
It is possible that a connection cannot be established.
Check your headset's instruction manual to find out how
to delete connections to other devices. Delete the Blue-
tooth connection between the headset and the dguard
module and try again.
INFO
You can check the status of your Bluetooth connection
in the dguard
reception",
INSTALLING THE dguard
system.
®
button flashes slowly and the system is started.
®
button lights up permanently, the sys-
®
system's Bluetooth connection mode, press the
®
button flashes at irregular intervals and the
®
module may not be detected.
®
(Chapter "4.7.2 Testing Bluetooth
app
®
p. 35).
SYSTEM
®
EN
button
®
®
21

Publicité

Table des Matières
loading

Table des Matières