Installing The Dguard ® Button; Installing The Dguard ® Button With Handlebar Adapter - digades DGUARD Mode D'emploi

Ö You have connected the cable harness to the vehicle battery and to
the positive terminal of the power circuit activated by the ignition on
your vehicle.
3.2 Installing the dguard
The dguard button is the main operating unit on your motorbike. While
®
you ride, a green LED will inform you about the current system status
(Chapter „4.3 System status and troubleshooting", p.
the dguard button to make an emergency call manually.
®
INFO
The dguard
dlebar adapter. Installation with the handlebar adapter de-
pends on whether your steering rod offers enough space.
3.2.1 Installing the dguard
Observe the following requirements at the installation location:
• Ensure that there is sufficient space on the steering rod of your motor-
bike to fit the handlebar adapter.
• You will require a screwdriver and a hot air dryer.
• Select the hose clip that matches the diameter of your steering rod.
hose clip for diameter 18 mm to 29 mm
9
hose clip for diameter 28 mm to 39 mm
9
Fig. 6: Installation position of the dguard
INSTALLING THE dguard
button
®
button can be installed with or without a han-
®
button with handlebar adapter
®
button
®
SYSTEM
®
23). You can also use
EN
13