digades DGUARD Mode D'emploi page 15

INSTALLING THE dguard
1 dguard
2 Handlebar adapter
3 Hose clip with shrink sleeves
1. Pull the shrink sleeve with the required length over the hose clip.
!
EN
2. Use a hot air blow dryer to shrink the shrink sleeve.
3. Guide the hose clip through the openings on the handlebar adapter.
4. Ensure that the cable with the 3-pin connection X3 is long enough to
reach the installation location on the handlebar and that your steering
movements are not impaired.
5. Ensure that the recess on the handlebar adapter is positioned on the
handlebar.
6. Fix the hose clamp with the handlebar adapter to the handlebar and
tighten it with a screwdriver.
7. Clean the handlebar adapter and the dguard
the adhesive pad
grease.
14
button
®
WARNING!
Ensure that there are no flammable materials in your
vicinity.
INSTRUCTION
The dguard button can only be placed in one direction on
®
the handlebar adapter. Before applying the adhesive pad,
check the installation direction of the dguard
the handlebar adapter.
(Fig. 4/3)
INSTRUCTION
The adhesive surfaces of the adhesive pad
be dry and free of dust and grease. Clean the adhesive
surfaces thoroughly before sticking.
SYSTEM
®
and remove all residue of dust, moisture or
button on
®
button thoroughly for
®
(Fig. 4/3)
must