BROWNING
Some functions of the oven enable you to brown
the surface of the food by activating the grill once
cooking is complete.
PRESS v TO BROWN
When the display shows the relevant message, if
required press
to start a five-minute browning
cycle. You can stop the function at any time by
pressing
to switch the oven off.
. FAVORITES
Once cooking is complete the display will prompt you
to save the function in a number between 1 and 10
on your list of favorites.
ADD FAVORITE?
If you would like to save a function as a favorite and
store the current settings for future use, press
otherwise, to ignore the request press
Once
has been pressed, press the
the number position, then press
Please note: If the memory is full or the number chosen has
already been taken, the oven will ask you to con rm
overwriting the previous function.
To call up the functions you have saved at a later
time, press
: The display will show your list of
favorite functions.
1. CONVENTIONAL
Press
or
to select the function, confirm by
pressing
, and then press
. CLEANING
•
SMARTCLEAN
Press
to show "Smart Clean" on the display.
Smart clean
Press
to activate the function: the display will
prompt you to do all actions needed to obtain the
best cleaning results: Follow the indications and then
press
when done. Once you have done all steps,
when required press
Please note: It is reccommended to do not open the oven
door during the cleaning cycle to avoid a loss of water vapor
that could get an adverse e ect on the nal cleaning result.
An appropriate message will start flashing on the
display once the cycle has finished. Leave the oven to
cool and then wipe and dry the interior surfaces with
a cloth or sponge.
.
or
to select
to confirm.
to activate.
to activate the cleaning cycle.
•
AUTOMATIC CLEANING PYRO
Do not touch the oven during the Pyro cycle.
Keep children and animals away from the oven
during and after (until the room has finished
airing) running the Pyro cycle.
Remove all accessories - including shelf guides - from
the oven before activating the function. If the oven is
installed below a hob, make sure that all the burners
or electric hotplates are switched off while running
the self-cleaning cycle. For optimum cleaning results,
remove excessive residuals inside the cavity and
clean the inner door glass before using the pyrolytic
function. We recommend only running the Pyro
function if the appliance contains heavy soiling or
gives off bad odours during cooking.
Press
to show "Pyro" on the display.
Pyro
Press
or
to select the desired cycle, then press
to confirm. Once a cycle has been selected, if
desired, press
or
to set end time (start delay),
then press
to confirm. Clean the door and remove
all accessories as prompted, then close the door and
press
when done: the oven will begin the self-
cleaning cycle, while the door locks automatically:
a warning message appears on the display, along
with a countdown indicating the status of the cycle
in progress. Once the cycle has been completed, the
door remains locked until the temperature inside the
oven has returned to a safe level.
Please note: remove water from the drawer before pyro
cycle activation
•
DRAIN
The drain function allows the water to be drained in
order to prevent stagnation in the boiler. This product
has been developed in order to automatically run
a drain cycle once cooking has been stopped/has
ended. Approximately 30min after the stop/end of
cooking, the oven will automatically drain the system,
moving the residual water into the drawer (be careful
not to remove the drawer after cooking). Once done,
the drawer can be extracted and emptied.
We recommend emptying the drawer as soon as the
drain is completed, after the cooking cycle.
If needed, a manual drain can in any case be executed
by the user following the instruction below.
Select the "Drain" function
with the water drawer properly
inserted in the oven, press
and wait for the cycle
to automatically run. The
average duration for full load
drainage is about one minute.
Once done, the drawer can be
extracted and emptied.