Rotary SPM32-S Mode D'emploi page 60

INDEX
7.7 COMPLETION AND CHECK
- Operate the down run control, manually setting the lower limit switch. Downward movement should stop.
- Operate the up run control until the carriages are fully raised and make sure the upper limit switch engages to stop these.
- Fill the post tanks with ESSO GEAR OIL GX 85W – 140 up to indicated level (refer to ch. 10).
- Fit in the pulley sensor plate on both columns Fig. A. Check that there is a gap of 0.5 mm between the sensor and the pulley (Fig. B).
- Fit in the covers as shown in Fig. C:
• Fit in the cover (1) by fixing it to the supports (2);
• Fit in the cover (3) by fixing it to the cover (1) and to the supports (4)
• Fit in the cover (5) by fixing it to the covers (1) and (3).
The identification plate must be always clearly visible after installation.
D
E
C
B
1
EN_20 0474-M006-0
Fig. A
A
C
F
G
2
4
A B
5
TBEI TBEI
M6X20 M6X12
Q.T. 16 Q.T. 4
A
C
A C
SPM32-S
Fig. B
C D E
ROND. DADO ES. ROND.
Ø6,4 MEDIO Ø6,4
NERA ZN
Q.T. 20 Q.T. 4 Q.T. 4
F G
TE ROND.
M6X14 ELAST.
Ø6,4
Q.T. 4 Q.T. 4
3
Fig. C