Rotary SPM32-S Mode D'emploi page 54

INDEX
5.2 FLOORING REQUIREMENTS
The lift must be installed on a flat, horizontal floor capable of bearing the LOADS TRANSMITTED TO THE SUPPORTING
FLOOR shown in the table (fig. B). The minimum requirements are:
a) Concrete quality: C25/30 min
b) Floor minimum thickness: 160mm (net of any floor and related screeds) (*)
It is advised to consult a qualified technician for installation suitability
(*) Minimum thickness depends on the block type used
The floor must be perfectly flat and horizontal (if not, the base must be shimmed only in the areas indicated with the arrow A.
B= Fixing holes
EN_14 0474-M006-0
Q max 3700Kg
R1 1200 Kg
R2 800Kg
SPM32-S
Fig. A