Angelo Po 0N0FT1G Manuel D'utilisation page 28

ENGLISH
Lighting
Important
The fi rst time the griddle is switched on, wash
the plate to remove the protective grease and
any dirt, then switch on the appliance and
preheat it for about 2 hours at the tempera-
ture of 180°C.
Turn on the appliance's circuit breaker to con-
1)
nect it to the electrical mains.
Turn on the gas supply tap.
2)
Press the knob
3) (A)
(pos. ).
1
Press and while keeping button (B) pressed, to
4)
light the pilot light.
Keep the knob pressed for about 15 sec. to pri-
5)
me the thermocouple.
Press and turn the knob (A) anti-clockwise
6)
(pos. ) to the maximum temperature and leave
2
it there for about 2 minutes, then turn the knob
to the temperature required.
Minimum
temperature
(°C)
Iron plates
10
SWITCHING THE BURNER ON AND OFF
iand turn it anti-clockwise
Maximum
temperature
(°C)
USE AND OPERATION
B
A
3
Turning off
Turn the knob clockwise (pos. 1) to turn the
1)
burner off . The pilot light will remain on to al-
low the burner to be re-lit.
Turn the knob clockwise (pos. 3) to turn off the
2)
pilot light.
Turn off the knob to ensure safety.
3)
A
1
2
3413720_ut_GB