Angelo Po 0N0FT1G Manuel D'utilisation page 109

ADJUSTMENTS
INSTRUCTIONS AND WARNINGS FOR ADJUSTMENTS
The appliance's main functions do not require
any special adjustments by specialist staff except
the settings made during use by the user.
INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS
Important
Before carrying
procedure, activate all the safety devices
provided and decide whether staff at work
and those in the vicinity should be informed.
In particular, turn off the gas supply tap, cut
off the electricity supply using the master
switch and prevent access to all devices that
might cause unexpected health and safety
hazards if turned on.
Also make sure that during the maintenance
procedure, that the operator is always able
to check whether the plug is disconnected
from the power outlet.
To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Take out the screws (C) and take down the
3)
dashboard (B).
Unscrew the nozzle (D) and replace it with the
4)
one suitable for the type of gas in use (see ta-
ble at back of manual).
Replace the control panel (B) and the knobs
5)
(A) on completion of the operation.
3413720_inst_GB
ADJUSTMENTS
REPLACING PARTS
out any replacement
REPLACEMENT OF THE BURNER NOZZLE
If worn parts have to be replaced, use original
spare parts only. The manufacturer declines
all responsibly for injury or damage to
components due to the use of non original
parts, or extraordinary work on the appliance
which may modify the safety requirements
without the manufacturer's authorisation.
When ordering components, follow the
instructions provided in the parts catalogue.
A
C
B
ENGLISH
C
D
13