BLUEFIN Fitness HX7 8TG Pro Manuel D'instructions page 7

ASSEMBLY
INSTRUCTIONS
1
Connect the Central Support Tube by inserting Part A into Part B. Secure
with 3 x Hex Screws & 3 x Flat Washers to the front & back.
2
Connect the Power Connection Cable to the Sensor Wire on your Base Plate
(Part C). Feed the connected cable through the assembled Central Support
Tube.
3
Insert the Central Support Tube (Parts A & B) to the Base Plate (Part C) &
securely fasten using 2 x Hex Screws.
4
Attach the connected cable to the Sensor Wire on your Control Console (Part
D) & securely attach your Control Console (Part D) to the Central Support
Tube (Parts A & B) using 2 x Hex Screws & 2 x Flat Washers.
5
Attach 2 x Bottom Support Poles (Parts E) to the Base Plate (Part C) using 2
x Hex Screws & 2 x Flat Washers. Tighten to secure.
6
Attach 2 x Top Support Poles (Parts F) to the 2 x Bottom Support Poles
(Parts E) using 4 x Hex Screws & 4 x Flat Washers. Tighten to secure.
7
Attach 2 x Top Support Poles (Parts F) to the Control Console (Part D) &
Central Support Tube (Parts A & B) using 4 x Hex Screws & 4 x Flat Wash
ers. Tighten to secure.
8
Attach Bottle Holder (Part G) to the Central Support Tube (Parts A & B)
using 2 x Crosshead Screws.
NB/ You must ensure that the Power Connection Cable was securely
attached to the Sensor Wires on the Base Plate & Control Console.