Vetus BOWPRO Manuel D'installation page 10

ENGLISH
4 .6 Configuration of multiple control panels
Up to four control panels can be configured (Group Code A, B, C or D).
Use one group code per control panel.
On ANY additional panel, perform the following actions in the or-
der indicated:
Switch off the panel, see 4.4, and wait 5 seconds before starting the
configuration procedure below.
BOW PB-1 BOW PB-2
10 seconds
1. Put the panel in configuration mode.
• Press and hold both buttons, BOW PB-1 and BOW PB-2, for 10 sec-
onds.
During the first 6 seconds, LED (1) flashes blue and the buzzer will
continuously signal a didididididi ..... (. . . .). Keep pressing the "ON /
OFF" button. After 10 seconds the buzzer sounds the signal didididi-
dah (. . . - -). Release the buttons.
2. Press both buttons BOW PB-1 and BOW PB-2 twice simultane-
ously.
Led (1) flashes blue and you hear the signal, di-dah-di ( . - . ). The panel
is now in configuration mode.
4 .7 Restore factory settings
Switch off the control panel to be restored (see 4.4) and perform the
following actions:
• Press and hold both buttons BOW PB-1 and BOW PB-2 for 30 sec.
After 15 sec, the red LED starts flashing. After 30 sec, the blue LED
comes on.
• Release both buttons.
• Press both buttons BOW PB-1 and BOW PB-2 once, simultaneous-
ly, to confirm the recovery process.
10
021003.11
B
BOW PB-1
dididididididid ( . . . . . . )
6 seconds
(1) BLUE, ashing
3. Short press BOW PB-1 or BOW PB-2 to set the control panel group
code. Repeat until the desired group is selected.
The colours of the LEDs indicate the group code of the control panel.
Group
1 (A)
2 (B)
3 (C)
4 (D)
4. Press both BOW PB-1 and BOW PB-2 buttons once, simultaneous-
ly, to confirm the setting.
Installation manual Bowpro push-button control interface CANVXCSP
C
A
BOW PB-2
ON/OFF
dididididah ( . . . . − )
4 seconds Con guration mode
LEDs
(1) blue, flashing
(2) red, flashing
(1) blue and (2) red, flashing alternately
(1) blue and (2) red, flashing simultaneously
(1) BLUE
(2) RED
30