VELTIUM LITE Zero Guide De L'utilisateur page 52

7. MANAGING THE CHARGER
FROM THE VELTIUM APP
Communications
Select the mode in which the charger will connect to the Internet to enable real-time remote
communication with the VELTIUM App:
Wi-Fi: Press the Connect button and follow these steps:
1. The VELTIUM App will search for Wi-Fi networks visible to the device. To do this, the App will
display a window with the message "Veltium Wants to Join Wi-Fi Network "WF_XXXXXXXX",
press Join to connect with your charger.
2. Once conected, the VELTIUM App will show a list of visible Wi-Fi networks, including their
signal strength and protection level. Select the Wi-Fi network to which you want the charger
to connect. If the network is protected, enter the password in the pop-up window and press
Connect.
3. The VELTIUM App will automatically proceed with the necessary actions to connect the
charger to your chosen Wi-Fi network. Once the process is complete, you must press Finish.
Local network: Scroll through the selector. If the charger is in a local area network, after a few
seconds the screen will display the IP address assigned to it.
Restart
Pressing the Restart button will power off and restart the charger, rebooting its operating system.
It does not affect the charger's configuration up until that time. This function should only be used
if the charger is unresponsive and fails to respond to the user's actions and commands. If you
have any doubts, consult the User Support service using the
* *
Only for Only in LITE Uno and
ADMINISTRATOR users LITE Kubo chargers
52
Contact button of the App.