VELTIUM LITE Zero Guide De L'utilisateur page 36

3- CHARGER STATUS AND COLOUR
CODE
LITE chargers come with a LIGHT INDICATOR enabling you to check its status according to the
following colour code:
NORMAL STATUS
AVAILABLE (Green):
vehicle connected but the charger is not detecting it because it is blocked (Refer to section 7.1
CONFIGURATION of this USER GUIDE for more information on Lock Control).
CONNECTED (Blue):
There are two reasons for the charger being in this status:
• There is an active schedule, and the charger is currently not within the daily charging period.
• The vehicle is not demanding power for some reason, such as:
· The battery is already full.
· The vehicle has its own charging schedule or is undergoing a technical stop in
charging.
· There is no available power at home due to exceeding the contracted power for
other household consumption.
For more information on this point, consult section 7.1 SETTINGS of this USER GUIDE.
The charger will remain in this state until the charging cable is disconnected.
CHARGING (Flashing
TEMPORARY STATUS
RESTARTING (Sweeping green + Initial buzz):
when instructed to do so from the SETTINGS screen in the VELTIUM App, when the electric power
is restored (or when the charger is booted up for the first time) or after a firmware update. This
process can take 20 to 30 seconds depending on the charger model.
UPDATING FIRMWARE (Flashing purple):
occur when instructed to do so from the SETTINGS screen in the VELTIUM App (or automatically
in the LITE Uno or LITE Kubo chargers when they are configured to do so and are connected to
the Internet). The charger will automatically reboot at the end of the process. This process can
take from 5 to 10 minutes depending on the charger model.
CONNECTING TO THE METER (Sweeping green from the centre out):
The charger is searching for the Meter and trying to connect to it.
If the indicator light displays a status other than described here, consult
the 8. TROUBLESHOOTING section of this USER GUIDE.
The charger is ready for use and either has no vehicle connected or has a
The charger has detected that the vehicle is connected, but it is not charging.
blue): The charging process has started and the vehicle battery is charging.
The charger is updating the firmware. This process will
The charger is restarting. This process will occur
36
*
Only LITE Uno and
LITE Kubo chargers