VELTIUM LITE Zero Guide De L'utilisateur page 46

7. MANAGING THE CHARGER
FROM THE VELTIUM APP
These are the steps for its configuration in each of the LITE charger models:
LITE ZERO
1- Dynamic power control
Select No if you do not have any measuring device installed for Dynamic Power Control, or if you
do not want the charger to perform load balancing.
If you select No, the charger will only consider the fixed value of the
current intensity you have selected on the Charge ruler between 1.4kW
(6A) and 7.4kW (32A), and it will allow you to select the maximum value
in relation to the installation data defined for the charger (refer to the
previous point, Installation data).
Otherwise, select Yes
2- Tariff periods
Select the number of periods in the power term of your electricity contract (1 or 2)
3- Contracted power
Select a Contracted
consumption of your home and electric vehicle.
If you have any doubts, please refer to your electricity bill.
1 tariff period
and proceed with the configuration
power, that must not, under any circumstances, exceed the combined
2 tariff periods
46