Sony Glasstron PLM-S700 Mode D'emploi page 47

Symptom
The battery pack is not
charged.
The black, red, and green
dots do not disappear.
The picture color is
different.
The picture gets out of
position in the PC mode.
Noises appear on the
picture in the PC mode.
The POWER switch does
not function.
Cause
The battery pack is not installed
properly.
The battery pack is completely dead.
The supplied AC power adapter is
not used.
The LCD is made with high-
precision technology. However,
black points or bright points of light
(red, blue, or green) may appear
constantly on the LCD screen. This
is not malfunction.
(Effective dots: more than 99.999%)
The color intensity and hue are not
adjusted.
The external display output signal
of the connected computer does not
match the supported input signal.
The input signal does not match to
the supported specification. See
"Signal compatibility" (page 35).
In this case, the picture does not
appear correctly.
The horizontal frequency of the
signal does not match to the
supported specification.
In this case, the flicker may appear
on the right edge of the picture.
—
Remedy
Install the battery pack properly
(page 41).
Replace the battery pack with a new
one (page 41).
Use the supplied AC-PLM3 AC
power adapter.
—
Adjust the color intensity and hue in
the menu screen (page 40).
Change the screen resolution and the
vertical frequency on your PC to
match the supported output
frequency (page 35). Refer to the
instruction manual of your PC.
Change the screen resolution or the
vertical frequency of the external
display output signal on your PC to
match the supported vertical
frequency (page 35). Refer to the
instruction manual of your PC.
Change the display mode on your PC
to the external monitor only (page
39).
Disconnect the AC power cord from
the wall outlet. After three minutes,
reconnect the AC power cord.
47
-US